Skip to content
+44 (0)1204 863290 [email protected]

Momentive IS5628E One Component Flowable High Strength Silicone Adhesive Sealant

Click Here To Download Detailed IS5628E Technical Data Sheet

Momentive IS5628E Description

IS 5628E one-component, ready-to-use, adhesive/sealant is a flowable consistency product specially developed for applications where high strength is required.

On exposure to atmospheric moisture at room temperature this product cures to a very tough, durable, resilient silicone rubber.

IS 5628E utilizes an acetoxy cure system, releasing small amounts of acetic acid vapours from the sealant during cure

Momentive IS5628E Available Online

Key Performance Properties of IS5628E

  • One-component, no mixing, easy-to-use
  • Flowable
  • Room temperature condensation cure
  • Very high strength
  • High and low temperature resistance (-60°C to +200°C)
  • Excellent adhesion to silicone rubbers
  • Excellent electrical insulation properties
  • Excellent weatherability, ozone, and chemical resistance
Click Here To Download Detailed IS5628E Technical Data Sheet

Key Performance Applications of IS5628E

  • Bonding silicone HCR gaskets together
  • Seam sealer
  • Bonding silicone coated fabric

Instructions For Use – Surface Preparation

IS 5628E will bond to clean surfaces without the aid of primers. These surfaces typically include many metals, glass, ceramic, and silicone rubber. A preliminary
check should be made to determine bonding effects for each specific application. For difficult-to-bond substrates, use of a primer will usually improve adhesion.

Momentive performance materials silicone primers SS4004P, SS4044P and SS4179 are recommended for use with this adhesive/sealant. Where adhesion is required, surfaces should be thoroughly cleaned with a suitable solvent such as iso propylalcohol (IPA) or methyl ethyl ketone (MEK) to remove dirt,
oil and grease. The surface should be wiped dry before applying the adhesive/sealant.

Momentive performance materials Silicone IS 5628E adhesive/sealant may be applied directly to clean substrate. Where broad surfaces are to be mated, sealant should be applied in a thin, less than 6 mm diameter, bead or ribbon around the edge of the surface to be bonded.

For more information on the complete range of Silicone adhesives, encapsulants and potting compounds available from Silicone Solutions click here 

Back To Top